Sunday, April 25, 2021

How to Charge Battery for Jungheinrich Forklift EJD 220

This instruction show you guide on how to charge battery for Jungheinrich forklift EJD 220 truck.

Charging the battery with a stationary charger
Charging the battery

Jungheinrich ForkLift JETI-SH-Judit 4.36 Full

 
Requirements
– Expose the battery, see "Exposing the battery" on page 40.


Procedure
• Disconnect the battery connector (46) from the truck connector.
• Connect the battery connector (46) to the charging cable (47) of the stationary
charger.
• Start charging in accordance with the charger operating instructions.
The battery is charging.


Completing battery charging, restoring the truck to operation
NOTE
If charging has been interrupted, the full battery capacity will not be available.
Requirements
– The battery is fully charged.
Procedure
• Complete charging in accordance with the charger operating instructions.
• Disconnect the battery connector (46) from the charging cable (47) of the stationary
charger.
• Attach the battery connector (46) to the industrial truck.
The truck is now ready for operation.

09.2020 JETI ForkLift v4.36 4.34 (Jungheinrich Judit) Free Download

Charging the battery with an on-board charger
DANGER!
Risk of electric shock and fire
Damaged and unsuitable cables can cause electric shocks and can overheat,resulting in fires.
XAlways use mains cables with a maximum length of 30 m.
Local regulations must be observed.
XUnwind the cable reel fully when using it.
XAlways use original manufacturer’s mains cables.
XInsulation safety, acid and caustic ratings must comply with the manufacturer's
mains lead.
XThe charging connector must be dry and clean when used.


NOTE

Improper use of the on-board charger can cause material damage
The on-board charger consisting of a battery charger and battery controller must not
be opened. If faulty, contact the manufacturer’s customer service department.
XThe charger must only be used for batteries supplied by Jungheinrich or other
approved batteries provided it has been adapted by the manufacturer's customer
service department.
XBatteries must never be swapped from truck to truck.
XDo not connect the battery to two chargers simultaneously. 

http://www.car-auto-repair.com

Fendt MT 1100 Tractor SCR System Error Pressure Drop Test Failure Solution

Here is the instruction show you guide on how to solve Fendt MT1100 tractor SCR system error. Pressure drop test failure. Preparations: AG...