Toyota Repair:How to use X431 Initizlize Toyota Servo Motor

Servo motor initialization is available under work support menu of AC of X431 TOP software.TOYOTA-16 connector or CAN BUS connector is used for non-CAN system. CAN BUSII connector is used for CAN BUS system.

For Toyota Spare Part Catalog,please check here:Toyota spare parts catalog epc


Launch X431 Toyota Related Topics:
Toyota Yaw Rate Acceleration Sensor and VSC Light Reset by Launch X431
Toyota Crown 2013 All Keys Lost & Remote Programming by Launch X431


This function is used to initialize the parameter of actuator of servo motor, and to initialize the communication between ECU and actuator after replacing ECU or demounting battery.

The main procedures are introduced as below:

Toyota Camry Sedan ABS System Alarm Troubleshooting

A Toyota Camry sedan with a mileage of about 95,000 kilometers. The car appeared ABS system alarm symptoms.

Fault diagnosis: 
First, fault codes are 31 (front right wheel speed sensor), 32 (front left wheel speed sensor), 33 (right rear wheel speed sensor), 34 (rear left wheel speed sensor). The analysis considers that the possibility that four wheel speed sensors and associated lines are damaged or defective at the same time is extremely small. The failure point may be that the ECU is faulty or interfered with.

Toyota TIS Techstream Software Free Download

Because other vehicle control systems work properly, the possibility of ECU failure is also small. Finally, the fault point is locked in electromagnetic interference. After searching, it was found that the shielded cable of the wheel speed sensor was severely worn out. Since the vehicle's ABS sensor is of the electromagnetic type, the signal voltage generated during operation in the low-speed zone is extremely weak, and the ABS requires high-sensitivity signal voltage to adjust the magnitude of the wheel braking force through the ECU. In order to ensure the accuracy of the signal, a shield mesh is provided on the wheel speed sensor.

Toyota All Key Lost Programming

Once the shield mesh is damaged, high-frequency electromagnetic waves on the vehicle will interfere with the normal operation of the wheel speed sensor, resulting in failure of the ABS or malfunction. The self-diagnosis system will issue an alarm. Repair the fault point, clear the fault code, test everything is normal, troubleshooting.

Toyota Trouble Repair