This post show you guide on how to install Webasto heating systems for Hyundai ix35.
Microcat V6 Hyundai KIA EPC
Preparaitons:
- Open the fuel tank cap, ventilate the tank.
- Close the fuel tank cap again.
- Disconnect the battery "earth" or "ground" connection.-Depressurisethe cooling system.
- Copy the factory number from the original type label to the duplicate type label.
- Remove years that do not apply from the duplicate label.
- Attach the duplicate label (type label) in the appropriate place.
- Disconnect the battery "earth" or "ground" connection.
- Remove the windscreen wiper.
- Remove the coolant reservoir cap and the coolant reservoir.
- Remove the underride protection.- Remove the underbody trim on the left in front of the tank.
- Remove the seat surface of the rear bench seat.
- Open the tank-fitting service lid.
- Remove the fuel-tank sending unit in accordance with the manufacturer's instructions.
- Remove the glove compartment.
- Remove the entrance strip on the front passenger's side.
- Remove the A-pillar trim in the front passenger's side footwell.
- Pull up the shift lever sleeve (only for digital timer).Remove page 25 "Operating Instructions for End Customer" and add to the vehicle operating instruc-tions..
Steps:
Pull in red (rt) wire and black (sw) wire into protective sleeving A. Pull green/white (gn/ws) wire into protective sleeving B and red (rt) wire into protective sleeving C.
Hyundai ix351315910D_EN6Preparing electrical systemOnly with automatic air-conditioning!Cutting protective sleeving to lengthPull in red (rt) wire and black (sw) wire into protective sleeving A. Pull green/white (gn/ws) wire into protective sleeving B and red (rt) wire into protective sleeving C.Preparing linesIPCU view on the contact side!IPCU is preprogrammed with the default set-tings of model year 2011. The default values must be checked during the function check on the vehicle and adjusted.
1Protective rubber plug2Wiring harnesses of fan controller, heater control
Loosely mount angle bracket 1.2Remove clip, M6x20 bolt, large diameter washer, flanged nut3M5x16 bolt, washer, retaining plate for fuse holder, K3 relay, flanged nut4Fuses F1-3 connected.
Do not install the metering pump wiring harness until later togeth-er with fuel pipe along the origi-nal vehicle fuel line on the underbody
Connection to 2-pin connector 1 from the fan motor.Produce connections as shown in wiring dia-gram.2Red (rt) wire from fuse3Red (rt) wire from K3/87a4Black (sw) wire from K3/305Red (rt) wire from connector GM
Connection to 2-pin connector 1 from the fan motor.Produce connections as shown in wiring dia-gram.2Red (rt) wire of fan relay3Red (rt) wire from IPCU/154Red (rt) wire from K3/87a5Black (sw) wire from K3/306Green/white (gn/ws) wire from IPCU/867Red (rt) wire
Connection to 4-pin connector 4 from the fan controller.Produce connections as shown in wiring dia-gram.1Black (sw) wire from IPCU/A2Red (rt) wire from IPCU/E3White/black (ws/sw) wire for A/C control unit pin 22 (36)5White/black (ws/sw) wire of connector for fan controller, pin 4Connect-ing fan con-trollerProduce connections as shown in wiring dia-gram.1Brown (br) wire IPCU/85 with cable lug2Original vehicle earth point
