Wednesday, April 14, 2021

How to Repalce Cooling System Water Temperature Regulator for Caterpillar C11 Engine

This instruction show you guide on how to Repalce Cooling System Water temperature Regulator for Caterpillar C11 Engine.

Caterpillar SIS 2020 2019 Full EPC+Service Manual Free Download

Replace the water temperature regulator before the water temperature regulator fails. This is a recommended preventive maintenance practice.


Replacing the Caterpillar water temperature regulator reduces the chances for unscheduled downtime.

Caterpillar ET 2020B Electronic Technician Software Free Download


A water temperature regulator that fails in a partially opened position can cause overheating or overcooling of the engine.


A water temperature regulator that fails in the closed position can cause excessive overheating. Excessive overheating could result in cracking of the cylinder head or piston seizure problems.


A water temperature regulator that fails in the open position will cause the engine operating temperature to be too low during partial load operation. Low engine operating temperatures during partial loads could cause an excessive carbon buildup inside the cylinders. This excessive carbon buildup could result in an accelerated wear of the piston rings and wear of the cylinder liner


CAT ET 2020C & 2019C Full Service Download


Failure to replace your Caterpillar water temperature regulator on a regularly scheduled basis could cause severe engine damage.
Caterpillar engines incorporate a shunt design cooling system and require operating the engine with a water temperature regulator installed.
If the water temperature regulator is installed incorrectly, the engine may overheat, causing cylinder head damage. Ensure that the new water temperature regulator is installed in the original position. Ensure that the water temperature regulator vent hole is open.
Do not use liquid gasket material on the gasket or cylinder head surface.
Refer to the Service Manual for the replacement procedure of the water temperature regulator, or consult your Caterpillar dealer.
Note: If only the water temperature regulators are replaced, drain the coolant from the cooling system to a level that is below the water temperature regulator housing.

CAT SIS Caterpillar SIS EPC Software Download

Fendt Vario 700 S4 1001 Crossgate Lever Calibration Guide

This instruction show you guide on how to calibrate 1001 Crossgate Lever for Fendt Vario 700 S4 tractor.   Related Contents: FENDT Fendias 2...