Here show the maintenance and repair information for Volvo heavy duy truck.
Volvo PROSIS Offline Parts+Repair Installation Service
Brake System
Brake Cams and Slack Adjusters
For further information concerning component specifications
see service information in Group 1, “Oil and Filter
Change Intervals for Volvo Components,” publication
number 175-001, and appropriate vendor literature.
For further information concerning brake cams see service
information in Group 5, “Q Plus LX500 and MX500
Cam Brakes Literature,” publication number 514–003,
and appropriate vendor literature.
Lubricate the brake cam bushings using a lithium-based
grease with EP additives and consistency NLGI No. 2.
Fill grease until old grease has been pushed out past
the seal and new grease can be seen flowing.
Lubricate the slack adjusters using a lithium-based
grease with EP additives and consistency NLGI No. 2.
Fill grease until old grease has been pushed out past
the splined shaft area, and adjustment pawl and new
grease can be seen flowing.
Volvo trouble repair
Air Dryers
Air dryers have internal maintenance systems that clean
out the accumulated moisture frequently and can therefore
work with long maintenance intervals. Eventually the
drying medium will be filled up and the cartridge will
need to be changed. Change cartridge when there is
more water being drained in the daily emptying of the
tank than usual. This is a progressive development and
the time interval will be different from application to application.
Dryer manufacturers recommend changing cartridge every
2 to 3 years but intervals need to be adjusted for
application. The only dryer with regular maintenance is
the Midland, where the coalescent filter needs changing
every year.
Note: If a vehicle is operated in a severe weather environment,
It is recommended to change the air dryer
cartridge prior to the severe weather season.
Steering System
For further information concerning component specifications
see service information in Group 1, “Oil and Filter
Change Intervals for Volvo Components,” publication
number 175-001, and appropriate vendor literature.
For axle forward models, grease the steering shaft Ujoints
every 4 months. A more frequent maintenance
interval may be required if the vehicle is operated under
severe driving conditions.
http://www.car-auto-repair.com
Fendt Vario 700 S4 1001 Crossgate Lever Calibration Guide
This instruction show you guide on how to calibrate 1001 Crossgate Lever for Fendt Vario 700 S4 tractor. Related Contents: FENDT Fendias 2...
-
Here I want to share this guide on how to build WIFI connection for Scania VCI-3 V2.21 .And if you have higher version,the method is same.Ho...
-
Cummins CM850 and CM2850 engine fault code 2311,Electronic Fuel Injection Control Valve Circuit - Condition Exists. Fuel pump actuator circu...
-
It is provided for using this function, that the engine is operating in min-/max governor or allspeed-governor mode (f.e. not fixspeed). Ser...