Monday, September 13, 2021

Clean Still iGo neo Forklift Truck Components for ASSISTANCE Mode

Clean Still iGo neo Components for ASSISTANCE Mode

Preparing the components for cleaning ACAUTION If water penetrates the electrical system, there is a risk of a short circuit occurring!
-Never clean the components used for ASSIS-
TANCE mode using devices such as high-pressure cleaners or rotating brushes.
-While cleaning the rest of the truck, avoid cleaning the components used for ASSISTANCE mode and only clean these components in accordance with the instructions specified below.

STILL STEDS Forklift 8.20 8.18 2020 EPC & Diagnostics Free Download

Risk from damage to electrical components when cleaning!
Only the authorised service centre is permitted to clean the components used for ASSISTANCE mode inside the truck.
-Contact the authorised service centre.
-Park the truck securely.
-Disconnect the battery male connector.
-Contact the authorised service centre to arrange for the components used for ASSIS-
TANCE mode inside the truck to be cleaned. Cleaning the optics covers(S300 safety la-
ser scanner,R2000 laser scanner, foot protection sensors)

 

Cleaning the optics covers(S300 safety laser scanner,R2000 laser scanner, foot pro-
tection sensors)
A CAUTION Abrasive cleaning materials can damage the surfaces of components!
Using abrasive cleaning materials that are unsuitable for plastics can cause plastic parts to dissolve or become brittle. The covers of optical sensors can become cloudy.
-Do not use aggressive cleaning materials (e.g.
acetone, solvents).
-Do not use any abrasive cleaning materials.-Clean the optics covers(inspection windows) on the S300 safety laser scanner, the R2000 laser scanner and the foot protection sensors regularly and in the event of contamination. 

Still Steds Navigator Forklifts 8.20 R2

-A static charge causes dust particles to accumulate on the optics cover. To clean the optics cover, use the antistatic plastic cleaning material listed in the table.


-Remove any dust from the optics covers using a clean, soft brush.
-Moisten the SICK optics cloth with the antistatic plastic cleaning agent. Use the damp cloth to wipe the light output window on the optics covers.
Cleaning other components used for ASSISTANCE mode
-Regularly clean the LED signal lights usinga soft, damp cloth without cleaning agents.
-Clean the remote control using a brush and a damp cloth. Do not use alcohol, solvents or cleaning materials.

Fendt Vario 700 S4 1001 Crossgate Lever Calibration Guide

This instruction show you guide on how to calibrate 1001 Crossgate Lever for Fendt Vario 700 S4 tractor.   Related Contents: FENDT Fendias 2...