Thursday, December 9, 2021

SsangYong Rexton Compression Pressure Test Guide

This instruction show you guide on how to do compression pressure test for SsangYong Rexton 2.7XDi.

The compression pressure test is to check the conditions of internal components (piston, piston ring, intake and exhaust vale, cylinder head gasket). This test provides current engine operating status.

SsangYong EPC Parts Catalog Free Download


Notice
• Before cranking the engine, make sure that the test wiring, tools and persons are keeping away from moving
components of engine (e.g., belt and cooling fan).
• Park the vehicle on the level ground and apply the parking brake.
• Do not allow anybody to be in front of the vehicle

• Disconnect the fuel rail pressure sensor connector to cut off the fuel injection.
• Discharge the combustion residues in the cylinders before testing the compression pressure.
• Apply the parking brake before cranking the engine.

1. Warm the engine up to normal operating temperature (80°C).
2. Disconnect the fuel rail pressure sensor connector to cut off the fuel injection.
3. Place the diagram sheet to compression pressure tester.

4. Remove the glow plugs and install the compression pressure tester into the plug hole.
5. Crank the engine for approx. 10 seconds by using the start motor.
6. Record the test result and measure the compression pressure of other cylinders with same manner.
7. If the measured value is not within the specifications,perform the cylinder pressure leakage test.If the measured value of the compression pressure test is not within the specifications, perform the cylinder pressure leakage test.

SsangYong EPC+Online VIN+Online Service Manual

Fendt Vario 700 S4 1001 Crossgate Lever Calibration Guide

This instruction show you guide on how to calibrate 1001 Crossgate Lever for Fendt Vario 700 S4 tractor.   Related Contents: FENDT Fendias 2...