Wednesday, August 14, 2019

Xprog-M Reads BMW E39 EWS3 Motorola 0D46J

This article show you guide on how to use XPROG-M programmer to read BMW E39 EWS3 Motorola 0D46J chip.

Preparation:
Newest XPROG v5.84 Software Free Download & Installation Guide
XPROG Programmer Interface





The EWS 3 Immobilizer unit , in the BMW E39 car body, is above the pedals, on the left.


remove it.


take the board out of the case.


The immobilizer is assembled on a Motorola microcontroller with a mask of 0D46J . Read it will be the Xprog-M programmer .


Open the program, go to Device s – Immobilizers – BMW – EWS3 .


looking at the connection diagram.


According to the scheme, connect the programmer Xprog-M to the immobilizer block EWS 3 .


Click the Read button …


… And the firmware Motorola 0D46J is read.



Job’s done!
http://www.car-auto-repair.com

Fendt Vario 700 S4 1001 Crossgate Lever Calibration Guide

This instruction show you guide on how to calibrate 1001 Crossgate Lever for Fendt Vario 700 S4 tractor.   Related Contents: FENDT Fendias 2...