This article show you guide on how to repair Benz 722 transmission trouble to adjust it.
1. The intermediate lever #2 and notched lever #3 are held in relation to each other with two 10 mm hex head bolts,#4 and #4.(Figure 4)
2. Loosen these two bolts and adjust levers, as necessary, to arrive at the condition described in Step 4.
CONTROL PRESSURE LINKAGE ADJUSTMENT MODEL 280SE/8,300SEL/8-2.8.
To check:
1. The vertical push rod from the bell crank on the engine block to the injection linkage cross shaft should have free travel.
2. With the injection linkage in the idle position and the transmission control pressure rod fully back, the vertical rod should fit free when the free play is fully extended.
Benz Xentry Diagnostic Software download
Mercedes Benz 722 Transmission To adjust:
1. Adjust length of vertical push rod at ball joint ends.
CONTROL PRESSURE LINKAGE ADJUSTMENT, MODEL 220/8-SOLEX CARBURETOR
1. Disconnect rod between carburetors and remove dashpot. Carburetors must be in idle position.
2. Intermediate rod to rear carburetor must have free travel.
3. Disconnect intermediate rod to rear carburetor at intermediate lever. When fully extended, rod must fit tension-free.
4. Adjust intermediate rod ball ends accordingly.
5. Replace dashpot and reconnect carburetor connecting rod.
MODEL 220/8-STROMBERG CARBURETOR(Figure 5)
1. Disconnect pull rod (7) and push back to stop on transmission.
Adjust pull rod at ball joint (8) to fit free of tension.
2. With the carburetor in the hot idle position,(off choke, vacuumthrottle control clear) adjust control rod(i2) with bali joint(11)
to fit free when fully extended.
