Volvo Techtool test and calibration operations that can be carried out depend on the product connected to Tech Tool and the user's level of authorization. Note that the screen images shown in the help text may differ from those in Tech Tool depending on the product that is being tested and the user's level of authorization.This instruction show you guide on how to use Volvo Techtool software to perform test and calibration.
Related Contents:
The first time you select an operation which requires communication with control units after manual matching, the program reads information from the control units. This may take a minute or two. The program make sure that the control units that store the chassis ID and serial number all contain the same chassis ID and serial number.
If the control units which store the chassis ID/Serial no. contain different chassis IDs/Serial numbers, no programming operations except MID XXX Control unit, programming can be carried out (XXX=MID-number).
Note: Testing and calibration operations should not be performed on control units that have different chassis IDs/manufacturing nos., since there is a risk that the result of the operation could be incorrect or that the function could be negatively affected.
Run a test or calibration
Under Test and Calibrate you can select operations to test or calibrate a product.
1 Select an operation by clicking on it.
Note: The functions can be sorted either as functions or function groups.
2 To run the operation in simulation mode, select Run as simulation.
3 Click Start to start the operation.
4 Follow the step-by-step instructions displayed.
https://www.car-auto-repair.com
